Skip to content

RDRKL 10-120 (K)

Three-phase compact rectifier transformers

Request a custom solution
RDRKL 10-120 (K) — Three-phase compact rectifier transformer

Standard Version

  • with downstream three-phase bridge rectifier,
  • Input 3 AC 380/400/420 V, output DC 24 V, residual ripple < 5%

Capacitor Design

  • with downstream three-phase bridge rectifier and capacitor,
  • Input 3 AC 380/400/420 V, output DC 24 V, residual ripple < 2%

General

The RDRKL series, like the RDRK series, was developed specifically for use with programmable logic controllers (PLCs). The transformers are very well dimensioned and voltage-stable, which gives a particularly flat characteristic between no-load and load, so that overvoltages or undervoltages critical to a PLC do not occur even where supply fluctuations are increased.

  • The rectifiers are protected against short-duration current surges and voltage peaks.
  • The protective circuit of the capacitor version is provided by a protection board carrying the corresponding varistor, film capacitor and discharge resistor.

Design

  • Open, horizontal design, for stationary use, for installation in equipment and mounting in dry rooms; separate windings; all connections via tracking-resistant screw-type terminal blocks. The terminals are finger- and back-of-hand safe to UVV (BGV A3).
  • IP00, insulation class E, max. ambient temperature 40 °C (ta40°C/E)
  • In the capacitor version the dimensions change slightly. The mounting dimensions remain unchanged.
  • Other versions on request (fuses, voltages, connections, etc.)